Filter
Top Products
28
English
CY-VM7203W
29
English
CY-VM7203W
Installation
(continued)
27 28
Dashboard
Mounting Collar
Mounting the Unit
Installation Procedures (When Using Mounting Collar )
Note:
The car model, installation conditions and combination
of the units used may impose some restrictions on
opening and closing the monitor as well as on the angle
and position to which the monitor can be adjusted.
IMPORTANT
When this unit is installed in dashboard, ensure that there
is suffi cient air fl ow around the unit to prevent damage
from overheating, do not block any ventilation holes on
the unit.
Insert the Mounting Collar into the dashboard,
and bend the mounting tabs out with a
screwdriver.
After installation, reconnect
the negative () battery
terminal.
Establish the rear connection of the unit.
After fi xing Power Connector , fi x the rear of the unit to
the car body by either method (a) or (b) shown at right.
Fastening the Mounting Collar
How much to bend the tabs will vary depending
on the car. Bend them with a screwdriver to
fasten the Mounting Collar securely in the
dashboard.
Insert the unit into Mounting Collar .
Secure the clamp plate of Mounting Collar to the hook
of Mounting Spring .
Insert Trim Plate .
Power Connector
Mounting Bolt
(5 mm)
Tab
Method for Fixing the Rear of the Unit
(a) Using the Rear Support Strap (b) Using the Rubber Cushion
(Option)
Fire wall of car
3 mm
Mounting Bolt (5 mm)
Rear Support Bracket
(Provided on the Car)
Rubber Cushion (option)
Mounting Bolt (5 mm)
Hex. Nut
Tapping screw
Method for Fixing the Mounting Spring
Two holes of the mounting spring allow you to select between two mounting types as shown below.
(A) Regular Installation Method (B) Deeper Installation Method
Caution
Method (B) is not available in some types of cars.
Mounting Spring
Flat-Head Screw
(5 mm6 mm)
Rear Support Strap
Clamp plate
A few millimeters of console projecting
Flat-Head Screw
Less projecting
Flat-Head Screw
Flat-Head Screw
Flat-Head Screw
Attach the Mounting Springs to the unit.