Filter
Top Products
[
6
]
Pelco Manual C1506M (3/00)
IRD2024 WIRING
Front View of Receiver
24V
AC
PAN/TILT CAM PWR
I F Z C
LENS
AUX1 AUX2
5V
CNN
CO
PWR CX
IN OUT
VIDEO
TLC
CC
~
+
Rear View of Receiver
1. Connect power to the 24 VAC INPUT connector on the rear of the receiver. The receiver’s power re-
quirement is a maximum of 5 vA, not including the camera and pan/tilt. Refer to the pan/tilt manual for
its power requirements. Do not turn on power.
If necessary, refer to Table A in the
Wiring Tables
section to determine appropriate wire sizes for 24
VAC applications.
2. Make sure the P/T SELECT switch on the rear of the receiver is set toward 24 VAC. The 115/230 VAC
switch position is used only with the ERD2200.
3. Connect the pan/tilt controls (up, down, left, right, and common).
4. Connect the camera power (24 VAC).
5. Connect the motorized lens controls (iris, focus, zoom, and common).
6. Connect video.
VIDEO IN comes from the camera.
VIDEO OUT goes to the controller.
If necessary, refer to Table B in the
Wiring Tables
section to determine appropriate coaxial cable
types for video applications.
7. Connect the auxiliary outputs (optional).
AUX 1 is a 5 VDC, 20 mA maximum, open collector output. Use the auxiliary:
• To operate low current relays
• To turn on or off a Pelco window wiper that has TTL circuitry
AUX 2 is a normally open/normally closed (Form C) relay. Relay contacts are rated at 1A at 24 VDC
or .5A at 115 VAC.
8. Double check all wiring connections, and then turn on power.
24 V
AC
INPUT
ERD OPTION
P/T SELECT
115/230
V
AC
24 V
AC
~
~
~