Filter
Top Products
EN 34
Reset picture and sound
You can restore the default picture and
sound settings, while the channel installation
settings remain the same.
1. While you watch TV, press .
2. Select [Setup] > [TV settings] > [General
settings] > [Factory settings], then press
OK.
3. Select [Reset], then press OK.
All TV settings (except for channel settings)
are reset to the default factory settings.
Channels
Automatic installation
When the TV was switched on for the first
time, a full installation of channels was
performed.
To change your language, country and
reinstall all available TV channels, you can run
this full installation again.
Start installation
Note: If you are prompted to enter a code,
enter '8888'.
1. Press .
2. Select [Setup] > [Search for channels] >
[Reinstall channels], then press OK.
3. Select your country, then press OK.
4. Select your network, then press OK:
[Antenna (DVB-T)]: Access free-to-air
antenna transmissions.
[Cable (DVB-C)]: Access cable
transmissions.
5. Follow the onscreen instructions to select
other options, if any.
The start menu for channel search is
displayed.
6. Select [Start], then press OK.
7. Once the channel search is complete,
select [Finish], then press OK.
Tip: Press LIST to see the channel list.
Note: When digital TV channels are found,
the list of installed channels may display
empty channel numbers. You can rename or
reorder these channels.
Install analogue channels
You can search and store analogue TV
channels one by one.
Step 1: Select your system
Note: Skip this step if your system settings
are correct.
1. While you watch TV, press .
2. Select [Setup] > [Channel settings] >
[Channel installation].
3. Select [Analogue: Manual installation] >
[System], then press OK.
4. Select the system for your country or
region, then press OK.
Step 2: Search and store new TV channels
1. While you watch TV, press .
2. Select [Setup] > [Channel settings] >
[Channel installation].
3. Select [Analogue: Manual installation] >
[Search channel], then press OK.
4. Find the channel:
If you know the channel frequency,
enter it with the Navigation buttons or
Numeric buttons.
If you do not know the channel
frequency, search for the next
frequency that has a strong signal.
Select [Search], then press OK.
5. After you have found the correct channel,
select [Done], then press OK.
6. Select [Store as new channel], then press
OK to store the new TV channel.
Note: If the reception is poor, reposition
your antenna and repeat the procedure.
Install digital channels
If you know the channel frequency of the
channels you want to install, you can search
and store digital channels one by one. For
best results, contact the service provider.
1. Press .
2. Select [Setup] > [Channel settings] >
[Channel installation].