Filter
Top Products
16 EN
Tune to a detected station
1 Press to exit the system menu.
2 Press again to access the list of detected
stations.
»
is displayed.
3 Press / repeatedly or rotate
until the name of the target station is
displayed.
4 Press to start listening.
Program radio stations
You can assign a sequence number to a
detected station. Afterwards, you can quickly
tune to it by pressing the corresponding
numeric button on the main unit.
Note
•
Before the programming, make sure that the scanning
is complete.
• You can store a maximum of six stations in each band.
Program stations automatically
1 Press and hold to access the system
menu.
» [DAB SCAN] is displayed.
2 Press / repeatedly until [DAB
STORE] is displayed.
3 Press .
» [STORING] is displayed.
» The product starts programming DAB
radio stations automatically.
» Earlier programmed stations are
replaced with the latest ones.
» After the programming is complete,
the rst programmed station is
broadcast.
• To tune to a programmed radio
station, press its corresponding
numeric button
, , ,
, , or .
Program stations manually
1 Tune to the target detected station (see
‘Tune to a detected station’ on page 16).
2 Press / repeatedly to select a band.
3 Press and hold a numeric button ,
, , , , or to assign
a sequence number to the station.
» [SAVED] is displayed.
» The station is programmed with the
sequence number.
4 Repeat the steps above to program more
stations.
• To tune to a programmed radio
station, press its corresponding
numeric button
, , ,
, , or .
Display DAB information
The name of current DAB station is displayed.
You can also view the other information.
To cycle through available information, press
DISP repeatedly.
• Dynamic label segment (DLS)
• Signal strength
• Program type (PTY)
• Ensemble name
• Frequency
• Signal error rate
• Bitrate codec
• Time
• Date