Philips CE153DR Car Stereo System User Manual


 
8 EN
Tip
The pin arrangement for the ISO connectors depends
on the type of your vehicle. To avoid damage to the
unit, connect properly.
Connect the DAB radio receiver
Note
The DAB radio receiver and DAB radio antenna are
not bundled. Consult your local retailer for purchase.
Make sure that no lead other than the DAB radio
antenna contacts the antenna connector of the DAB
radio receiver.
Risk of injury: Never install the DAB radio receiver and
its accessories on the airbag cover.
Risk of overheating: Do not x the DAB radio receiver
to the metal surface of the main unit.
Risk of electromagnetic interference: Do not install the
DAB radio receiver over any sensors or vents.
Risk of short circuit, malfunction, or damage to this
product: Do not alter the cable of DAB radio receiver
or dismantle the receiver box.
Risk of damage to the DAB radio receiver: Never pull
its cable when you remove it.
1 Connect the DAB radio receiver to the
main unit.
2 Connect a DAB radio antenna to the DAB
radio receiver.
3 Secure the DAB radio receiver to your car.
Mount into the dashboard
If the car does not have an on-board drive
or navigation computer, disconnect the
negative terminal of the car battery.
If the car battery is not disconnected, to
avoid short-circuit, make sure that the bare
wires do not touch each other.
1 Make sure that the car dashboard opening
is within these measurements:
183 mm
53mm
5mm