Filter
Top Products
Resetting the microprocessor
Pressing RESET lets you reset the micropro-
cessor to its initial settings.
The microprocessor must be reset under the
following conditions:
! Prior to using this unit for the first time
after installation
! If the unit fails to operate properly
! When strange or incorrect messages ap-
pear on the display
1 Turn the ignition switch OFF.
2 Press RESET with a pen tip or other
pointed instrument.
RESET button
Notes
! When using with a Pioneer navigation unit, if
you press RESET, be sure ACC OFFis se-
lected. If ACC ON is selected, correctopera-
tion may not be possible even if you press
RESET.
! After completing connections or when you
want to erase all memorized settings or return
the unit to its initial (factory) settings, switch
your engine ON or set the ignitionswitch to
ACC ON before pressing RESET.
Use and care of the remote
control
Installing the battery
Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus ( ) poles pointing in the proper di-
rection.
! When using for the first time, pull out the
film protruding from the tray.
WARNING
Keep the battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
CAUTION
! Use only one CR2025 (3 V) lithiumbattery.
! Remove the battery if the remote control is not
used for a month or longer.
! Do not recharge, disassemble, heat or dispose
of the battery in fire.
! Do not handle the battery with metallic tools.
! Do not store the battery with metallic materi-
als.
! In the event of battery leakage, wipe the re-
mote control completely clean and installa
new battery.
! When disposing of used batteries, please
comply with governmental regulationsor en-
vironmental public institutions rules that
apply in your country/area.
Before You Start
En
14
Section
02