Filter
Top Products
Initially, the unit is set for rear full-range speak-
er connection (FULL). When rear output is
connected to full range speakers (when FULL
is selected), you can connect the RCA sub-
woofer output to a subwoofer. In this case, you
can select whether to use the subwoofer con-
trollers (low pass filter, phase) built-in SUB.W
or the auxiliary FULL.
! When the multi-channel processor (e.g.,
DEQ-P8000) is connected to this unit, you
cannot operate this function.
1 Touch A.MENU and INITIAL and then
touch REAR SPEAKER.
2 Touch
or to switch the rear out-
put setting.
Touch
to select full-range speaker and
FULL appears in the display. Touch
to select
subwoofer and SUB. W appears in the display.
# When no subwoofer is connected tothe rear
output, select FULL.
# When a subwoofer is connected to therear
output, set for subwoofer SUB. W.
# When the rear output setting is SUB.W, you
cannot change the subwoofer controller.
3 Touch or to switch the subwoofer
output or non fading output.
Touch
to select subwoofer output and
SUB.W appears in the display. Touch
to se-
lect non fading output and FULL appears in
the display.
Notes
! Even if you change this setting, there is no
output unless you turn the nonfading output
(refer to Using nonfading output on page69)
or subwoofer output (refer to Usingsubwoofer
output on page 69) in the audio menu on.
! If you change the subwoofer controller, sub-
woofer output and nonfading output inthe
audio menu return to the factory settings.
! Both rear speaker leads output andRCA rear
output are switched simultaneously in this
setting.
Correcting distorted sound
You can minimize distortion that may be
caused by the equalizer curve settings.
Setting an equalizer level high can cause dis-
tortion. If high sound is crippled or distorted,
try switching to LOW. Normally, leave the set-
ting at HIGH to ensure quality sound.
! Only when the multi-channel processor
(e.g., DEQ-P8000) is connected to this unit,
you can operate this function.
1 Touch A.MENU and INITIAL and then
touch DIGITAL ATT.
2 Touch
or to switch the digital at-
tenuator setting.
Touch
to select low setting and LOW ap-
pears in the display. Touch
to select high
setting and HIGH appears in the display.
Switching the sound
muting/attenuation
Sound from this system is muted, attenuated
or mixed automatically in the following cases:
! When a call is made or received using a
cellular telephone connected to this unit.
! When the voice guidance is output from a
Pioneer navigation unit connected to this
unit.
1 Touch A.MENU and INITIAL and then
touch TEL/GUIDE.
Initial Settings
En
90
Section
17