Filter
Top Products
Notes
! Remember that if thefeature demo continues
operating when the car engine is turned off, it
may drain battery power.
! You can also turnon or off feature demo by
pressing DISPLAY while this unit is turned off.
For more details, see Feature demo mode on
page 12.
Switching the reverse mode
If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds.
1 Use MULTI-CONTROL to select
Reverse mode.
Reverse mode appears in the display.
2 Press MULTI-CONTROL to turn the re-
verse mode on.
ON appears in the display.
# To turn the reverse mode off, press
MULTI-CONTROL again.
Note
You can also turnon or off reverse mode by press-
ing BAND while this unit is turned off. For more
details, see Reverse mode on page 12.
Switching the Ever Scroll
When Ever Scroll is set to ON, CD text infor-
mation scrolls continuously in the display. Set
to OFF if you prefer the information to scroll
just once.
1 Use MULTI-CONTROL to select
Ever-scroll.
Ever-scroll appears in the display.
2 Press MULTI-CONTROL to turn the Ever
Scroll on.
ON appears in the display.
# To turn the Ever Scroll off, press
MULTI-CONTROL again.
Calibrating the RPMs
Follow the instructions below to measure the
RPM of your vehicle and records them. By
doing this, the tachometer of this unit can
work properly.
! Tachometer of this unit cannot work if you
do not perform the RPM calibration.
! In some vehicles, the tachometer may not
work properly even if you performed the
RPM calibration.
1 Park your vehicle in a safe place and be
sure to apply the parking brake.
2 Use MULTI-CONTROL to select
Calibration.
Calibration appears in the display.
3 Keep RPMs of the engine at 4000 rpm
and press MULTI-CONTROL.
To measure the RPM of your vehicle properly,
keep RPMs of the engine at 4000 rpm for a
few seconds.
When the RPM calibration is completed,
Completed is displayed.
# Some vehicles have a rev limiter that kicks in
early (e.g., 3000 rpm) while parking. In this case,
perform RPM measurement at2000 rpm.
# To switch between 4000 rpm and 2000 rpm,
push MULTI-CONTROL left or right.
Activating the BT Audio source
You need to activate the BTAudio source in
order to use a Bluetooth audio player.
Initial Settings
En
97
English
Section
15