Pioneer AVIC-90DVD Car Stereo System User Manual


 
55
Appendix
Appendix
Installing the Program
The program is installed to the Navigation Sys-
tem using the application disc.
This is not necessary if your dealer already
performed the installation.
When installing the program, you carry out the
following operations. When all the setup proce-
dures are completed, you can use the Navigation
System.
You cannot go back to the previous (pre-
upgrade) version of the application after
the software upgrade is completed. Also,
the map discs that were previously used
cannot be used. Instead, use the CNDV-
40MT DVDs as your new map discs.
1 Park your vehicle in a safe place.
Leave the engine on, and make sure that the
parking brake is on.
2 Insert the Pioneer DVD Map disc to the
disc loading slot of the Navigation Sys-
tem.
When upgrading, installation of the version
upgrade program starts immediately.
Once the installation of the program
starts, do not stop the engine of your vehi-
cle nor switch off the Navigation System
until the installation is completed and the
map of your surroundings or Audio screen
appears.
3 Press the NAVI/AV button to change the
navigation screen.
4 Touch “Yes/Oui”.
When you start the navigation unit for the first
time, you will see a confirmation message
asking if you wish to select another language.
English is the default language of the Naviga-
tion System. If desired, you can select another
language as shown.
To keep English, touch “No/Non”. After
this, proceed to Step 7.
When you want to select another lan-
guage, touch “Yes/Oui”, and proceed to
the next step.
5 Select the language from the list.
Touch the language you want to use.
Installation of the program, in the language
you chose, begins.
When the installation is complete, the open-
ing display appears.
1 Insert the disc while the vehicle is
parked.
2 Select the language used for the Navi-
gation System.
3 Setting the clock.