Filter
Top Products
INSTALLATION
1. Read this manual carefully and in its entirety before installing the
DCX-730.
2. Always disconnect the battery or remove the fuses for circuits you
will be working on.
3. Check for clearance of any hazards such as wiring harnesses or
heater core before mounting the equalizer to any panels in the
vehicle.
4. Mount the DCX-730 controller and processing module in a location
that is easy to access. The processing module should be mounted
within the passenger or trunk compartments. Do NOT mount the
processing module in the engine compartment.
5. Route all power wires and audio cables away from sharp metal
edges that can cause shorts to ground and any moving parts that
can tangle the wires such as heater controls or wiper motors.
6. Route all power and signal cables as far as possible from other
vehicle wiring harnesses. Loom when appropriate.
7. It is recommended that the DCX-730 processor be grounded at a
chassis point (preferably bare or scraped sheet metal) near to where
the processor is mounted. The DCX-730 controller should be
grounded at a chassis point (preferably bare or scraped sheet metal)
other than the factory head unit ground wire or under dash brackets.
8. Use only the supplied machine screws to mount the DCX-730 or
damage to the circuitry could occur.
CONTROLLER FEATURES
Controls and Display
The DCX-730 has the following features.
1. Mode. Press this button to return to the Home menu.
12 3 4
5
2