Filter
Top Products
Page 17 of 18
?
More information
For more information on using the fishfinder refer to:
Chapter 3 - Working with Waypoints
Chapter 6 - Using the Fishfinder of the C-Series Reference Manual
How do I change the range or shift the image?
D6736_2
How do I zoom in on an area of the screen?
How do I select the operating frequency?
Note: Using the range controls will affect all fishfinder windows.
*Selecting manual zoom range (xR) is described in the C-Series Reference Manual
Press
OK
Your system automatically adjusts the display depth range, selecting the shallowest that keeps the
bottom on the lower half of the window. You can however set this manually if required and move
the image within the selected page up or down:
The fishfinder uses dual frequency sonar - 50 kHz and 200 kHz - and can be used in auto or manual
modes. In auto mode it will automatically select the most appropriate frequency at which to operate.
Alternatively you have the option of manually selecting either frequency.
Press RANGE IN to
decrease the depth.
Press RANGE OUT to
increase the depth.
Press RANGE
(IN or OUT)
Turn to alter
shift value.
RANGE
IN
OUT
RANGE
IN
OUT
Press
RANGE
AUTO MAN
Press
RANGE SHIFT
XX FT
Select SINGLE
FISHFINDER
SETTINGS...
Press
FREQUENCY...
Press Select MAN
FREQUENCY
AUTO MAN
ZOOM...
Press Select pre-defined
zoom level
(x2, x3 or x4)*
ZOOM FACTOR
x2 x3 x4 xR
Select ON, for zoom
image only.
Select SPLIT, for zoom
and fishfinder image.
ZOOM
ON SPLIT MAN
Select the required
operating frequency
SELECT FREQ
200 50
FREQ MODE
SINGLE DUAL
Whats under the boat?
Using the fishfinder....
Card No. 15
TRANSDUCER
SETTINGS
ZOOM BOTTOM LOCK A - SCOPE PRESENTATION