Filter
Top Products
Chapter 5: Standard Chart Operations 5-9
Placing a Waypoint
• Moving a Waypoint
At the end is a section about using the ST60/80 Navigator Keypad to select,
edit, and name your waypoints.
Placing a Waypoint
The scenario Place and Goto a Waypoint on page 2-26 provides a simple
example of how to place a waypoint.
➤ To access the place waypoint soft keys, press MARKS:
➤ To place a waypoint at the cursor position or at the vessel position:
1. Press either the
PLACE WPT AT CURSOR or the PLACE WPT AT VESSEL soft
key. The waypoint is added to the waypoint list and tagged using the next
available number.
The waypoint soft keys are displayed until you move the cursor away from
the waypoint or press
CLEAR.
You can use the
EDIT WAYPOINT soft key to name the waypoint as
described in Editing Waypoints below.
2. Press
CLEAR or ENTER to remove the place waypoint soft keys.
➤ To place a waypoint as latitude/longitude using the Waypoint List:
1. Press
MARKS, followed by the WAYPOINT LIST soft key. The Waypoint List
and associated soft keys are displayed.
2. Press the
MAKE NEW WAYPOINT soft key followed by the LAT/LONG soft
key; the
WPT POSITION (LAT/LONG) screen is displayed, with it’s associated
soft keys. The waypoint is placed at the current vessel position, or if not
available, the cursor position.
D4169-1
PLACE WPT
AT CURSOR
PLACE WPT
AT VESSEL
WAYPOINT
LIST
MARKS
D5572-1
PLACE WPT
AT CURSOR
PLACE WPT
AT VESSEL
WAYPOINT
LIST
LOAD/SAVE
USER CARD
MARKS
PLACE WPT
AT CURSOR
PLACE WPT
AT VESSEL
D4163-1
GOTO
WAYPOINT
EDIT
WAYPOINT
ERASE
WAYPOINT
MOVE
WAYPOINT
MARKS
WAYPOINT
LIST
MAKE NEW
WAYPOINT