Filter
Top Products
1. Connect the CATV or antenna coaxial cable to the Antenna terminal on the rear of the monitor.
You need to use a coaxial antenna cable.
2. Turn on the monitor.
3. Select TV using the SOURCE button on the monitor's front.
4. Select a desired TV channel.
When using an interior antenna terminal:
Check the antenna terminal on the wall first and connect the antenna cable.
When using an outdoor antenna:
If you are using an outdoor antenna, use a professional for installation if possible.
To connect the RF cable to the antenna input terminal:
Keep the copper wire portion of the RF cable straight.
As this product is designed for NTSC signals only, you cannot view TV programs in countries
where PAL or SECAM signals are used.
Purchase the antenna cable, antenna converter and amplifier at your neighborhood electronics
store.
Is weak signal causing poor reception?
Purchase and install a signal amplifier for better reception.
3. Connecting DVD / DTV Set Top Box
Connect to the DVD / DTV Set Top Box input if the device has a DVD / DTV connector. You can watch
DVD / DTV simply by hooking up the DVD / DTV with the monitor as long as the power is on.
1.
Connect a AV cable between the component(Y, Pb, Pr) jacks on the Monitor and the Y, Pb, Pr jacks
on the DVD / DTV set top box.
2. Connect the Audio (R) and Audio (L) outputs on the DVD / DTV set top box to the Audio (R) and
Audio (L) inputs on the monitor using audio cables.
3. Select Component using the SOURCE button on the monitor's front.
Setup - Connecting to other devices