Filter
Top Products
32
Instructions for attaching a VESA compliant arm
An arm or stand based on the VESA standard
(purchased separately) can be attached to the
monitor.
Procurement of the arm or stand is at the custom-
er's discretion.
Arms or stands able to be used
Attachments must satisfy the following.
- Compatible with the VESA standard
- Have a gap of 100 mm x 100 mm between the
screw holes on the section to be attached
- Not be likely to fall off or break off after being
attached to the monitor.
How to attach the arm or stand
- Be careful not to overly bend the cable or add
extension cords as this could lead to malfunction.
- While following these instructions, please also
refer to the installation instructions in the
operation manual included with the arm or stand.
1. Remove the cable.
2. Spread out a soft cloth on a suitable horizontal
surface.
3. Being careful not to damage the monitor, gently
lay the monitor on it display-side down.
4. Remove the four screws and then remove the
stand from the monitor.
Notes:
- The stand is specially made for use with this
monitor. Once having removed the stand, never
attempt to attach it to another device.
- Once having removed the screws, store them
together with the stand and if the stand is ever re-
attached be sure to use the original screws. Using
different screws could lead to a malfunction.
5. Attach the arm to the monitor with the four
screws.
Note:
- The screws used to attach the arm should be M4
screws with a length of 6 mm ~ 8 mm protruding
from the surface to be attached. Using different
screws could lead to malfunction or may lead to
the monitor falling off,internal damaged,personal
injury.
6 - 8 mm
CAUTION!
Do not disassemble the stand. Parts may
spring out and cause injury.
CAUTION!
Securely grasp both the display and stand,
and gently tip over. When the monitor is
inclined, the stand may suddenly pop out
and cause injury.
Screw used to attach arm
Arm
Part of monitor to which
arm is attached