Filter
Top Products
11 GB/IE
i
T
A / TP (Traffic Announcement/Traffic
Program): Function to receive traffic updates.
i
EON (Enhanced Other Networks): I
f TA / TP
function is activated, while listening to a
broadcasting of a radio station the programme
switches automatically as soon as traffic updates
are broadcast. Traffic updates are then
broadcast at a pre-set volume.
i
PTY (Program Type): Function to receive
special program (e.g. rock music).
i
HiFi (High Fidelity): Quality standard for audio
replay devices.
i
D
IN 8 pole plug: adapter to connect electronic
HiFi device in accordance with DIN standard (e.
g. CD changer connection to a MP3 car radio
recorder).
i
I
SO plug: Adapter to connect electronic HiFi
devices
in accordance with International
Organization for Standardization.
L Preparation
The following auxiliaries and tools are required for
the connection and for the assembly, which are not
included in the delivery:
1
x ISO plug to connect car’s loudspeaker
1 x ISO plug to make 12 V DC connection
1
x Powered aerial connection with connector
1 x Pair of loudspeakers impedance 4 - 8 Ohm,
(incl. feed line)
3
x Fuse holder with fuse 15 A
1 x DIN assembly cut-out in car’s instrument panel
9 x Biscuit connectors
1 x Stripping tongs or cable stripping knife
1 x Screw driver
1 x Spanner with 8 mm opening
1 x Biro
To connect an antenna already installed in the
vehicle you may need:
1
x Antenna adapter (in accordance with the
Technical Data for the antenna)
To connect a CD changer you require:
1
x Connecting line with DIN-8-pole plug
To connect a final amplifier you require:
2
x Cinch connecting cable
(insula
tion and plug: white / red)
For the connection of a portable audio device
you require:
1
x Cinch connection cable / 3.5 mm jack
(insulation and plug: white / red)
To record MP3 or WMA formats you require:
1
x MMC approx. 1 GB storage capacity
or
1
x SD approx. 1 GB storage capacity
or
1
x USB memory stick approx. 1 GB storage
capacity
L Installation
L Removing the control panel
from the car radio
• Avoid hard contact with the display window 3.
• Press the “Open” button
4and allow the
control panel
1to reach the horizontal
position.
•
Push the control panel
1slightly to the left and
pull it forwards.
•
Store the control panel in the plastic box (see
also the illustration in the section “Attaching
the Control Panel”).
L
Installation of the DIN assembly
bracket into the car’s instrument
panel
• Completely unscrew the safety transport
screws
gpfrom the metal casing dt(see Fig. E)
and carefully remove the plastic frame
2
from the front of the device ct.
• Release the attachment points by slightly
raising the upper frame edge and pulling it
carefully towards the front.
•
Push the two installation keys between the
Safety / Preparation / Installation
KH2380_Content_UK.indd 11 12.09.2006 11:57:11 Uhr