Filter
Top Products
51
Message Display on the monitor
“
You can’t operate this command now.”
“This disc can’t be played.”
“All discs can’t be played.”
“Magazine is not loaded.”
“Magazine empty”
Message Display on the wired
remote commander
“
E-07”
Cause and/or Corrective Action
•The command you made is not available for the DVD during playback.
,With some DVDs, certain operations are prohibited. It depends on each disc.
•The command you made is not available on the screen currently displayed.
,If you advance to the next step on the screen, the command will become available.
•The region code is neither “the code printed on the rear of the unit” nor “ALL.”
, Use DVDs with the same region code printed on the back of the unit or “ALL”
(page 5).
•The audio-visual restricted function is activated.
, Change the parental level. See “Parental setup (Changing the parental level)”
(page 44).
•The colour system of the disc is incompatible with the one on your unit.
, Check the colour system of the disc. See “This Unit Can Play the Following Discs”
(page 5) .
•You tried to play a disc that you cannot play on this unit.
,Load a disc that this unit can play.
•You loaded the disc upside down.
,Load the disc properly.
•The disc is dirty.
,Clean the disc.
•Moisture has condensed on the laser lens of this unit.
,Remove the magazine from this unit and wait for about one hour.
•All of the discs in the magazine are those that this unit cannot play.
,Use the discs that this unit can play.
•You didn’t insert the magazine.
,Insert the magazine in this unit.
•There were no discs at all in the magazine.
,Insert a disc in the magazine.
Cause and/or Corrective Action
•During playback, the unit does not start to play. Because of scratches, and sticky
residue, etc., the unit cannot read the disc.
, Clean the disc.
, Change the disc.
Message Display
During operation, the following messages are displayed to help you understand easily.