Filter
Top Products
6
CDX-M800
4
Location of controls
Refer to the pages listed for details.
a SCRL (scroll) button
10
b DSPL (display mode change) button
10, 12
c Number buttons
(1) REP
11
(2) SHUF
11
To store stations/receive stored stations.
d EQ7 button
18
e MENU button
To display the menus.
f SOURCE (Power on/Radio/CD/MD*
1
/
AU X*
2
) button
To select the source.
g SEEK (</,) buttons
To skip tracks/fast-forward, reverse a track/
tune in stations automatically, find a station
manually/select a setting.
h SOUND button
16
i OFF (Stop/Power off) button
9, 21
j VOL (+/–) buttons
To turn up or down the volume.
k OPEN/CLOSE button
9
l MODE button
To change the operation.
m DSO button
19
n LIST button
13, 16
o DISC (M/m) buttons
To receive preset stations/change the disc*
3
,
skip albums*
4
/select a menu.
p ENTER button
To enter a setting.
q ATT button
17
*1
When an optional MD unit is connected.
*2
Available only when an optional Sony portable
device is connected to BUS AUDIO IN of the unit.
You cannot connect any optional CD/MD units at
the same time.
*3
When an optional CD/MD unit is connected.
*4
Available only when an optional CD unit with the
MP3 file control function is connected, and MP3 file
is played.
Card remote commander RM-X110
DISC
–
ATTOFF
SCRL
REP SHUF
DSPL
1
4
MODE
2
5
3
6
SOURCE
DISC
+
SEEK
+
SEEK
–
SOUND
ENTER
M
E
N
U
L
IS
T
EQ7 DSO
VO L
+
–
OPEN/CLOSE
DISC
–
SOURCE
DISC
+
SEEK
+
SEEK
–
In menu mode, the currently selectable button(s) of
these four are indicated with a “
v
” in the display.
Note
If the display disappears by pressing
(OFF)
, it cannot
be operated with the card remote commander unless
(SOURCE)
on the unit is pressed, or a disc is inserted
to activate the unit first.
Tip
Refer to “Replacing the lithium battery” for details on
how to replace the batteries (page 22).
(SEEK) (<):
to select
leftwards
(DISC) (M):
to select upwards
(DISC) (m):
to select downwards
(SEEK) (,):
to select
rightwards
SECTION 1
GENERAL
This section is extracted
from instruction manual.
(US, Canadian Model)
Connection example (US, Canadian Model)
5
The buttons on the unit share the same
functions as those on the card remote
commander.
a OPEN button 9
b Main display window
c IMAGE button 20
d qf Receptor for the card remote
commander
e qs RESET button 8
f OFF (Stop/Power off) button*
1
g SCRL (scroll) button
h DSPL (display mode change) button
i Sub display window
j SEEK/AMS (.m/M>) button
k MENU button
m LIST/CAT*
2
button
o
CLOSE (front panel close) button
9
p SOURCE button
q MODE button
r VOL (–/+) button
s DSO button
t EQ7 button
u SOUND button
v DISC (+/–) buttons
w ENTER button
x Z (eject) button 9
Main display side
Operation side
CDX-M800
continue to ne
xt page
t
Connection example (2)
Notes
(2-A)
• Be sure to connect the ground cord before connecting
the amplifier.
• If you connect an optional power amplifier and do not
use the built-in amplifier, the beep sound will be
deactivated.
Tip
(2-B- )
For connecting two or more CD/MD changers, the source
selector XA-C30 (optional) is necessary.
Exemple de raccordement (2)
Remarques
(2-A)
• Raccordez d’abord le fil de masse avant de raccorder
l’amplificateur.
•Si vous raccordez un amplificateur de puissance en
option et que vous n’utilisez pas l’amplificateur intégré,
le bip sonore est désactivé.
Conseil
(2-B- )
Dans le cas du raccordement de deux changeurs de
CD/MD ou plus, le sélecteur de source XA-C30 (en option)
est requis.
Ejemplo de conexiones (2)
Notas
(2-A)
• Asegúrese de conectar primero el cable de puesta a masa
antes de realizar la conexión al amplificador.
•Si conecta un amplificador de potencia opcional y no utiliza
el incorporado, los pitidos se desactivarán.
Consejo
(2-B- )
Cuando desee conectar dos o más cambiadores de CD/MD,
necesitará un selector de fuente XA-C30 (opcional).
BUS CONTROL IN
BUS AUDIO IN
Source selector*
Sélecteur de source*
Selector de fuente*
XA-C30
*
not supplied
non fourni
no suministrado
2
A
B
AUDIO OUT
FRONT
AUDIO OUT
REAR
BUS AUDIO IN
BUS CONTROL IN
SUB OUT (MONO)