Filter
Top Products
12
3 Switch the function of the stereo system
to the desired sound source (e.g. “CD,”
“MD,” “AM”or “FM”).
4 Set DIRECTION to g to record on
one side. Set it to s to record on
both sides.
5 Press zREC on the tape deck.
The tape deck stands by for recording. The
indicators on the zREC, H (for the top
side) and S buttons light up.
If you want to record starting from the
bottom side, press h (for the bottom side)
so the indicator on the h button lights up.
6 Press S on the tape deck.
Recording starts.
You can also start recording by pressing the
H or h button that is lit.
7 Start playing on the source component.
To Press
Stop recording x on the tape deck.
Pause recording S on the tape deck.
Tips
• The cassette indicator lights up in red when a
cassette is inserted and goes off when no cassette is
inserted.
• When you want to reduce the hiss noise in low-level
high-frequency signals, set DOLBY NR to ON
before step 5.
• Using the timer function on the stereo system, you
can record radio programmes at a preset time. For
details, refer to “Timer recording radio
programmes” in the stereo system operating
instructions. When you set the timer recording,
DOLBY NR and DIRECTION mode must be set on
the tape deck.
Additional Information
Precautions
On operating voltage
(for models with a voltage
selector)
Before operating the tape deck, check that the
operating voltage of your tape deck is identical with
the voltage of your local power supply.
On safety
• The unit is not disconnected from the AC power
source (mains) as long as it is connected to the wall
outlet (mains), even if the unit itself has been turned
off.
• Unplug the tape deck from the wall outlet (mains) if
it is not to be used for an extended period of time.
To disconnect the cord (mains lead), pull it out by
the plug. Never pull the cord itself.
• Should any solid object or liquid fall into the
component, unplug the tape deck and have it
checked by qualified personnel before operating it
any further.
• The AC power cord (mains lead) must be changed
only at a qualified service shop.
On placement
• Place the tape deck in a location with adequate
ventilation to prevent heat build-up in the tape deck.
• Do not place the unit in an inclined position.
• Do not place the unit in locations where it is:
— Extremely hot or cold
— Dusty or dirty
— Very humid
— Subject to vibration
— Subject to direct sunlight
Before placing a cassette in the
tape deck
Take up any slack in the tape. Otherwise, the tape
may get entangled in the parts of the tape deck and
become damaged.
When using a tape longer than
90 minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding
frequently. The tape may get entangled in the tape
deck.
Recording manually (continued)