Filter
Top Products
9
Other operations
To Do this
Stop playing Press x.
Pause Press S.
Press again to resume playing.
Fast-forward Press x, then M for the top
side.
Press x, then m for the
bottom side.
Rewind Press x, then m for the top
side.
Press x, then M for the
bottom side.
Find the succeeding
track* (AMS**)
Press M for the top side
during playback.
Press m for the bottom side
during playback.
Find the preceding
track* (AMS**)
Press m for the top side
during playback.
Press M for the bottom side
during playback.
Remove the cassette Press A on the tape deck.
Adjust the volume Turn VOLUME on the stereo
system.
* You cannot use the remote supplied with DHC-
MD595.
**The Automatic Music Sensor (AMS) feature
detects a blank space of more than four seconds
between tracks to locate tracks quickly.
Tips
• When you press `/1 (power) on the tape deck, only
the tape deck turns on. Press `/1 (power) on the
stereo system to turn on the stereo system.
• The cassette indicator lights up in red when a
cassette is inserted and goes off when no cassette is
inserted.
• Pressing H or h when the tape deck is off
automatically turns on the tape deck and starts
playing a tape if there is a cassette inserted (One
Touch Play) (DHC-MD313/333 only).
• Inserting the tape when the power is off
automatically turns on the tape deck only. Press
`/1 (power) on the stereo system to turn on the
stereo system.
• You can switch from another source to the tape
deck just by pressing H or h (Automatic
Source Selection).
• To start playing automatically from the beginning
of the tape after fast winding (Auto Play), press
H while holding down m (for the top side) or
press h while holding down M (for the bottom
side).
• To listen to a tape recorded with the Dolby noise
reduction system, set DOLBY NR to ON.
• Using the timer function on the stereo system, you
can wake up to music at a preset time. For details,
refer to “Wake up to music” in the stereo system
operating instructions. When you set the Wake-up
timer, DOLBY NR must be set on the tape deck.
Note
The AMS feature may not work in the following
cases:
— the blank space between tracks is four seconds
or less.
— the sound source recorded on the right channel
is different from that on the left channel as with
a KARAOKE tape.
— low volume or low sound continues for a long
time.
— the TV is too close to the tape deck.