Filter
Top Products
7
5 Connect A to A, and B to B using
the audio connecting cords. Insert the
plugs into jacks of the same colour.
The two audio connecting cords are the
same, so you can connect A or B using
either cord.
TC-TX595 rear panel
TAPE
L
R
AB
A
B
IN OUT
DHC-MD373 rear panel
TC-TX595 rear panel
TAPE
L
R
IN OUT
A
B
AB
DHC-MD333 rear panel
L : sound flow
* A l A
The sound signals of the CD, MD and TUNER
flow through the stereo system to the tape deck
when you record to tape.
** B l B
The sound signal of the tape deck flows to the
stereo system when you play a tape.
How to insert the plugs
Insert the plugs firmly into the jacks.
Not firmly inserted
Insert to here.
6 For models with a voltage selector, set
VOLTAGE SELECTOR to the position
of your local power line voltage.
220-240V
VOLTAGE SELECTOR
110-120V
7 Connect the mains lead to a mains after
you complete all the connections.
If the plug on this tape deck does not fit your
mains, detach the supplied adapter from the
plug (only for models equipped with an
adapter).
If there is no sound or the tape
does not record at first
operation
Make sure the plugs are inserted into the jacks
firmly.
• If the plugs are not inserted into both the A jacks
firmly, you may not be able to record the sound of
the CD, MD and TUNER onto a tape.
• If the plugs are not inserted into both the B jacks
firmly, you may not be able to listen to the sound of
the tape deck.
The plugs of the audio connecting cords may be
tight. Insert the plugs at the point shown in “How
to insert the plugs” in step 5.