Filter
Top Products
51
To setup up a multicast stream from the TANDBERG Content Server first edit the relevant
Template (WMV8-MulticastDefault.xml for the Transcoding line or H323-ASF-Multicast.xml for the
archiving lines) with the Template Editor.
Make a note of the Port used for the Network Output Information as this will be used later in the
creation of the new Publishing Point. If you create multiple Templates for Multicast Publishing
Points then you must choose different Ports for each.
NOTE: When selecting a port for the Network sink you should choose a number greater than
9000 as this will ensure you do not conflict with other port numbers used by the TANDBERG
Content Server.
Also note the name Streaming Path as you will use this in the creation of the Announcement.
Once you have completed the new Template give it a new name and save it.
Remember, you must set this template as the active template for a line before you can begin
using it.