KH1508i / KH1516i User Manual
32
F6 IP
This function allows you to select whether to assign the KH1508i / KH1516i’s
IP address dynamically (DHCP), or to give it a fixed IP address. Press [Enter]
to toggle between the choices.
If you toggle DHCP Enable to Off, specify the IP, Mask, and Gateway in the
appropriate fields.
Press [Esc] to exit after you have finished with your choice.
F7 SCAN
Pressing [F7] invokes Auto Scan Mode. This function allows you to
automatically switch among the available computers at regular intervals so that
you can monitor their activity without having to take the trouble of switching
manually.
The selection of computers to be included for Auto Scanning is made with
the Scan/Skip Mode setting under the F3 SET function (see page 26).
The amount of time that each Port displays for is set with the Scan
Duration setting under the F3 SET function (see page 26). When you
want to stop at a particular location, press the [Spacebar] to stop scanning
and exit Auto Scan Mode.
If the scanning stops on an empty port, or one where the computer is
attached but is powered Off, the monitor screen will be blank, and the
mouse and keyboard will have no effect. Simply wait - after the Scan
Duration time is up, the Scan function will move on to the next port.
As each computer is accessed, an S appears in front of the Port ID display
to indicate that it is being accessed under Auto Scan Mode.
While Auto Scan Mode is in effect, the console will not function normally.
You must exit Auto Scan Mode in order to regain control of the console.
While you are in Auto Scan Mode, you can pause the scanning in order to
keep the focus on a particular computer by pressing P. See Invoking Auto
Scan, page 37, for details.
To exit Auto Scan Mode, press [Spacebar] or [Esc].
