A SERVICE OF

logo

Open as PDF
next previous
Chapter 6. Administration and Configuration
73
Radius
If you are using a RADIUS server, set up its parameters as follows:
1. Check Enable Radius.
2. Fill in the IP addresses and Service Ports for the Primary and Alternate
RADIUS servers.
3. Set the time in seconds that the KH1508i / KH1516i waits for a RADIUS
server reply before it times out in the Timeout field.
4. Set the number of RADIUS retries allowed in the Retries field.
5. Key the Shared Secret character string that you want to use for
authentication between the KH1508i / KH1516i and the RADIUS Server
in this field.
6. Set the access rights for each user on the RADIUS server according to the
information in the table on the next page.