A SERVICE OF

logo

Open as PDF
next previous
102102 103
Return to the Top page
Audio Setting Up
Return to the Top page
Audio Setting Up
[3] (Front Source, Rear Source)
Selecttheaudiosourceforeach.
[∞], [5] (Rear VOL.)
Adjuststherearchannelvolume.
[Single Zone]
Touchtoturnoffthedualzonefunction.
NOTE
•Whentherearspeakersoundisswitched,the
audiosourcethatisoutputattheAVOUTPUT
terminalisalsoswitchedtothesamesource.
•Whenthedualzonefunctionissettoon,the
followingfunctionsarenotavailable.
•Outputfromthesubwoofer
•SubwooferLevel/BassBoost
(P.99)
•EqualizerControl/SpaceEnhancer
/ListeningPosition (P.100, 104,
106)
•DSPBypassControl
/SpeakerSetup/Car
TypeSetup (P.98, 95, 97)
Sound Effect
Youcansetsoundeffects.
1 Touch [Sound Effect].
Sound Effect screen appears.
See the following section for each setting.
• Set space enhancer
(P.104)
• Set highway sound
(P.104)
• Set up elevation (P.105)
• Set up realizer or supreme (P.105)
Controlling equalizer manually
1 Touch [Tone] in the Equalizer screen.
2 Set each item as follows.
FREQ
Adjuststhecenterfrequencyforeachrange.
Settingvaluesareasfollows.
Bass:60Hz/70Hz/80Hz/100Hz/110Hz/120Hz/
130Hz/150Hz(Defaultis“100Hz”.)
Middle:500Hz/1kHz/1.5kHz/2kHz(Defaultis
“1kHz”.)
Treble:10kHz/12.5kHz/15kHz/17.5kHz(Default
is“12.5kHz”.)
LEVEL
Adjuststhelevelofeachrange.
Eachsettingvalueiswithin-8dBand8dBand
defaultis“0dB”.
Q Factor
AdjustQvalueforbassandmiddle.
Settingvaluesareasfollows.
Bass:1.00/1.25/1.50/2.00(Defaultis“1.00”.)
Middle:1.00/2.00(Defaultis“1.00”.)
Bass DC EXT
TurnsBassDCEXTonoroff.Defaultis“OFF”.
Ifyouselect“ON”,thebasscenterfrequencyis
extendedtothelowregisterbyapproximately
20%.
[Flat]
Tonelevelbecomes0(flat).
Subwoofer Level
Adjuststhesubwoofervolume.Thissettingis
notavailablewhensubwooferissetto“OFF”.
SeeSpeaker setup (P.95).
Zone Control
Youcanselectdifferentsourcesforboth
frontandrearpositionsinthevehicle.
1 Touch [Zone Control].
Zone Control screen appears.
2 Touch [Dual Zone].
3 Set each source as follows.