eaker settings, the DTX-9909K eaker settings, the DTX
crophone cables connected to
Below is a list of the available speakers settings and their
speaker settings, press the Main Menu but-
nt panel or the Menu button on the remote
Using the Speaker Setting
1. Press the Main Menu button on the front panel to cycle
through all of the speaker settings.
2. Use the Input/Adjust control to change the parameters
1. Press the Menu button on the remote control to access
the Speaker Settings menu
buttons to cycle through all of the
buttons to change the parameters for
Available Speaker Settings:
speaker settings available in the
he Input/Adjust knob on the front panel or the
buttons on the remote control to select
- If your main speakers have a high ability for bass
reproduction. In this position, full-range signals present in
the main channels are output from the main speakers.
- If your main speakers do not have a high ability
for bass reproduction. However, if your system does not
include a subwoofer, do not select this position. In this
position, low bass signals are output from the subwoofer
he Input/Adjust knob on the front panel or the
buttons on the remote control to select
Choices: Large, Small, and
- If you have a large surround center speaker. The
entire range of the surround center signal is directed to
the surround center speaker.
- If your center speaker does not have a high ability
for bass reproduction. In this position, low bass signal
(100 Hz) in the center channel is output from the sub-
woofer speaker, or from the left and right main speaker if
the subwoofer setting is set to the “N (none)” position.
- Select this position if your system does not include
the center speaker. The center-channel will be output
from the left and right speakers instead.
