Filter
Top Products
3M Dynapro ET 350 Monitor User’s Installation Guide
28
Step 7:
Close enclosure
and hatch
Close enclosure
When you are finished adjusting the display settings, close the enclosure:
1. Close the bezel assembly and lock the latch screw with the Allen key.
2. If applicable, replace the four security screws. Tighten the screws to a
torque of 10 inch-pounds.
Close hatch
To close the hatch, insert the four #6-32 Phillips screws loosely. Using a
No. 1 Phillips torque screwdriver, gradually tighten diagonal pairs of
screws until all are equally tight at a torque of 7 inch-pounds. This may
require about three rounds of tightening.
Step 8:
Mount monitor
Two of the three ET 350 monitor models come with their own mounting/
sealing equipment and mounting instructions (and the instructions are also
available for download from www.3Mtouch.com
):
ET 350R monitor with a NEMA 4X panel gasket
ET 350L3 monitor with a NEMA 4X hatch
The ET 350L2 monitor does not come with mounting materials, but there
are optional mounting kits available from 3M Touch Systems (see below).
For details of the features of the three ET 350 monitor models, see
“Distinctive features of each model” on page 8.
Optional mounting kits
Each mounting kit comes with its own set of installation instructions (also
available for download from www.3Mtouch.com
):
Boom mount kit allows the monitor to be mounted on a post, boom or
suspension arm with a NEMA 4X sealed hatch or extended hatch.
Rack mount kit makes it possible to mount the monitor on a standard
19-inch industrial rack.
Desktop stand kit is a two-piece desktop stand option that allows the
monitor to be set on a desk, bench, or table top.
A
security hardware kit, also available from 3M Touch Systems, includes
four security screws and a security screwdriver that make it possible to
lock the back of the ET 350 monitor enclosure. Once the security screws
have been inserted, the monitor cannot be opened from the front by an
unauthorized user.
Warning
To reduce the risk of electric shock which could result in serious personal injury
or death, before removing the ET 350 monitor from its mounting, disconnect
power to the unit.