Filter
Top Products
IPPC-9151 Series Users Manual 10
2.1.1 PS/2 Mouse and Keyboard
If you wish to use a full-size desktop keyboard and PS/2 mouse with your
panel PC, follow these instructions:
1. Be sure the panel PC is turned off.
2. Attach the keyboard adapter to the 5-pin green port on the rear bottom
side of the rear cover.
3. Attach the mouse adapter to the 5-pin purple port on the rear bottom
side of the rear cover.
2.1.2 Parallel Port
The panel PC supports the latest EPP and ECP parallel port protocols for
improved performance and versatility with compatible printers or other
devices.
To connect the panel PC to a printer or other devices:
1. Make sure both the panel PC and the printer/devices are turned off.
2. Connect the 25-pin male connector of the printer cable to the 25-pin
female port on the panel PC labelled "parallel port."
3. If necessary, attach the other end of your printer cable to your printer,
and fasten any retaining screws.
4. Turn on the printer and any other peripheral devices you may have con-
nected to the panel PC. Then turn on the panel PC.
5. If necessary, run the panel PC's BIOS setup program to configure the
parallel port to respond as required by your printer and software operating
environment.
2.1.3 VGA port
An external VGA-compatible device may be connected to the system via
the 15-pin external port located on the rear of the system unit. The panel
PC simultaneously supports an external CRT monitor in addition to its
own LCD display.