Filter
Top Products
9-EN
This unit cannot receive HD Radio signals (digital terrestrial radio). In
order to activate the digital radio functions described below, an optional
HD Radio Tuner module must be connected through the Ai-NET bus.
iTunes Tagging lets you tag songs you hear on HD Radio stations with
your new CDA-117 and then preview, buy, and download them later
from your iTunes Tagged playlist the next time you sync your iPhone/
iPod. If the unit is connected to a Tagging compatible device, you can
use the iTunes Tagging function. For details, refer to the Owner’s
Manual of the Tagging compatible device.
Listening to Radio
1
Press SOURCE to select TUNER mode.
2
Press BAND repeatedly until the desired radio band is
displayed.
FM1 FM2 AM FM1
3
Press TUNEA.ME to select the tuning mode.
DX (Distance mode) LOCAL (Local mode) MANUAL (Manual
mode) DX
Note
• The initial mode is Distance mode.
Distance mode:
Both strong and weak stations will be automatically tuned in
(Automatic Seek Tuning).
Local mode:
Only strong stations will be automatically tuned in (Automatic
Seek Tuning).
Manual mode:
The frequency is manually tuned in steps (Manual tuning).
4
Press or to tune in the desired station.
Holding down or will change the frequency
continuously.
Note
• If Digital Seek is set to ON, the SEEK UP/DOWN functions only stop
on digital station frequencies while receiving an HD Radio signal. Refer
to “Digital Seek ON/OFF Setting” on page 25.
Presetting Stations Manually
1
Tune in the station you want to store. Press and hold, for at
least 2 seconds, any one of the preset buttons (1 through
6) into which you wish to store the station.
The display shows the band, preset number and station
frequency memorized.
Notes
• A total of 18 stations can be stored in the preset memory (6 stations for
each band; FM1, FM2 and AM).
• If you store a station in a preset memory which already has a station,
the current station will be cleared and replaced with the new station.
• If the (F) indicator is illuminated, turn off the indicator by pressing
FUNC., then you can perform the operation.
Presetting Stations Automatically
1
Press BAND repeatedly until the desired radio band is
displayed.
2
Press and hold TUNEA.ME for at least 2 seconds.
The frequency on the display continues to change while the
automatic memory is in progress. The tuner will automatically
seek and store 6 strong stations in the selected band. They will
be stored into preset buttons 1 to 6 in order of signal strength.
When the automatic memory has been completed, the tuner
goes to the station stored in preset location No.1.
Note
• If no stations are stored, the tuner will return to the original station you
were listening to before the auto memory procedure began.
Tuning to Preset Stations
1
Select the desired band, then press any one of the station
preset buttons (1 through 6) that has your desired radio
station in memory.
The display shows the band, preset number and frequency of
the station selected.
Note
• If the (F) indicator is illuminated, turn off the indicator by pressing
FUNC., then you can perform the operation.
Frequency Search Function
You can search for a radio station by its frequency.
1
Press and hold ENTER for at least 2 seconds in Radio
mode to activate Frequency search mode.
2
Turn the Rotary encoder to select the desired frequency.
3
Press ENTER to receive the selected frequency.
*
* Operation is not required during HD Radio reception.
Note
•Press ESC in the search mode to cancel. Or, the search mode will
be canceled if no operation is performed for 10 seconds.
Radio
FUNC.
Preset buttons
(1 through 6)
SOURCE/
BAND
/ESC
TUNE/A.ME
Rotary encoder/ENTER/