Filter
Top Products
7-EN
Accessory List
• Head unit ............................................................................1
• Power cable........................................................................1
• FULL SPEED™ Connection Cable...................................1
• Mounting sleeve.................................................................1
• Bracket key.........................................................................2
• Rubber Cap........................................................................1
• Hex Bolt..............................................................................1
• Face plate...........................................................................1
• Screw (M5 × 8)....................................................................4
• Owner’s Manual .......................................................... 1 set
Turning Power On and Off
Press SOURCE/ to turn on the unit.
• The unit can be turned on by pressing any other button except
/CD.
Press and hold SOURCE/ for at least 2 seconds to
turn off the unit.
• The first time power is turned on, the volume will start from level 12.
Initial System Start-Up
Be sure to press the RESET switch when using the unit for the first
time, after changing the car battery, etc.
1
Turn off the unit power.
2
Press RESET with a ballpoint pen or similar pointed
object.
Adjusting Volume
Turn the Rotary encoder until the desired sound is
obtained.
Lowering Volume Quickly
Activating the Audio Mute function will instantly lower the volume
level by 20 dB.
Press MUTE to activate the MUTE mode.
The audio level will decrease by about 20 dB.
Pressing MUTE again will bring the audio back to its
previous level.
Setting the Time
1
Press and hold
FUNC./SETUP
for at least 2 seconds
to activate the SETUP selection mode
.
2
Turn the
Rotary encoder
to select CLOCK ADJ, and
then press
/
ENT
.
3
Turn the Rotary encoder to set hour.
4
Press /ENT.
5
Repeat steps 3 and 4 above to set minute.
6
Press and hold
FUNC./SETUP
for at least 2 seconds
to return to normal mode.
• Pressing /ESC returns to the previous SETUP mode.
• If no operation is performed for 60 seconds, SETUP is canceled.
• To synchronize the clock to another clock/watch or radio time
announcement, press and hold
/ENT for at least 2 seconds after
setting the “hour”. Minutes will reset to 00. If the display shows over
“30” minutes when you do this, the time will advance one hour.
Getting Started
SOURCE/
Rotary encoder
FUNC./SETUP
6/DIMMER
MUTE
/ENT
/ESC
RESET switch