Filter
Top Products
11
Changing to CD/MP3/WMA/iPod
mode
u Press the SRCbutton
@
repeatedly until the
desired audio source is displayed:
• "CD": Inserted CD.
• "SD(HC)": Inserted memory card
• "USB FRONT" or "USB REAR": USB data
carrier connected to the front or rear.
• "IPOD FRONT" or "IPOD REAR": iPod con-
nected to the front or rear
• "AUX": Connected external audio source.
Notes:
• The respective audio source can be select-
ed only if a corresponding CD is inserted or
a corresponding device is connected.
• A connected iPod is initially selected un-
der "USB" and, as soon as the iPod is recog-
nised, under "IPOD".
• If the car sound system rst has to read
the data of a connected device or data car-
rier before the playback, the display shows
"READING". The duration of the reading
depends on the data volume and design
of the device or data carrier. If the device
or data carrier is defective or the trans-
ferred data cannot be played back, a corre-
sponding message appears on the display
(e.g. "CD ERROR").
Inserting/ejecting a CD
Inserting a CD
Risk of severe damage to the CD
drive!
Noncircular contoured CDs (shape CDs)
and CDs with a diameter of 8 cm (mini CDs) must
not be used.
We accept no responsibility for any damage to the
CD drive that may occur as a result of the use of
unsuitable CDs.
Note:
You must not hinder or assist the drive as it
automatically draws in the CD.
u Insert the CD with its printed side up into the
CD tray
5
until you feel a slight resistance.
The drive automatically draws in the CD and
checks its data. Afterwards, the playback
starts in CD or MP3 mode.
Note:
If the inserted CD cannot be played back, "CD
ERROR" is brie y displayed and the CD is au-
tomatically ejected after approx. 2 seconds.
Ejecting a CD
Note:
You must not hinder or assist the drive as it
ejects the CD.
u Press the
button
8
to eject an inserted
CD.
Notes:
• If a CD is ejected and not removed, the
drive will automatically draw it back in
again after approx. 10 seconds.
• You can also eject CDs while the car sound
system is switched o or whilst another au-
dio source is activated.
Connecting/removing a USB data
carrier
Note:
You can connect USB data carriers to the USB
port at the front of the device as well as the
rear USB port.
Connecting a USB data carrier
u Switch o the car sound system so that the
data carrier will be correctly registered.
u First, pull the protective cap of the USB port
:
to the front until it moves out of the port
and fold it to the right to connect a data car-
rier to the USB port at the front of the device.
u Connect the USB data carrier.
u Turn on the car sound system.
CD/MP3/WMA/iPod mode