Filter
Top Products
86
refer to the section on “Self-adjusting equal-
izer” or “Manual equalizer adjustment”.
The settings for “Rock to Vocal” are fixed
values which cannot be adjusted.
• Press / to select the desired set-
ting.
Switching the equalizer on/off
• To switch the equalizer off, press <<.
“EQ off” will appear in the top line of the dis-
play.
• To switch the equalizer on, press >>.
Self-adjusting equalizer
(Hi-fi self-adjustment)
This car stereo is equipped with a self-ad-
justing, adaptive 7-band equalizer for two
channels.
The left and the right channel can be ad-
justed electronically for each equalizer set-
ting.
Hi-fi self-adjustment
You can take electronic readings and store
them for three different situations, e.g.:
EQ 1 for the driver alone
EQ 2 for the driver and a front-seat pas-
senger
EQ 3 for passengers in the front and
back
To take the reading hold the microphone in
the corresponding position.
For EQ1 (driver alone), hold the microphone
directly where the driver’s head would be.
For EQ2 (driver and front-seat passenger),
hold the microphone between the driver and
front passenger seat and for EQ3, hold the
microphone directly in the centre of the ve-
hicle (left/right, front/rear).
These readings must be taken in a quiet
area. Outside noise will distort the results.
Make sure that nothing impedes the sound
being emitted from the speakers. The mi-
crophone must be connected to the car ster-
eo system.
Starting the hi-fi self-adjustment
The car stereo system must be switched on.
• Place the microphone as required for
the setting you want to store.
The reading will not be correct if the micro-
phone is held in the wrong position.
To start the hi-fi self-adjustment, activate the
DSA menu.
• Press DSA and EQ one after the other.
The setting selected last will appear in the
top line of the display.
DSA – Digital Sound Adjustment
• Press / to select the setting you
want to alter (EQ1, EQ2, EQ3).
To start the self-adjustment
• press ADJ and AUTO one after the
other.
“MicPos5” will appear in the top line of the
display, the countdown will begin.
Following the countdown, the fully automat-
ic self-adjustment will begin.
Noise which gradually increases in volume
will be emitted from the speakers; the top
line of the display will flash at the same time.
Make sure that your surroundings are as
quiet as possible while the reading is being
taken.
AtlantaRCM169 gb 95%® 10.06.2002, 12:30 Uhr86