BMW X3 (E83) Car Video System User Manual


 
20
Installation Instruction P/N 01 29 0 403 646
Monitor/Sound
Symptom Remedy
POWER button on Monitor
does not function. No function
or display.
Turn ignition ‘ON’.
Check vehicle's battery voltage.
Consult a BMW Technical Hotline
No picture on Monitor screen
during playback.
Confirm Monitor's power button is "ON"
Confirm Monitor's input is set to appropriate source.
Adjust monitor brightness.
Monitor's protective circuit is on because of high
temperature. Wait until temperature inside vehicle comes
down to normal monitor operating temperature.
Open connection with Monitor, AV Interface unit, or DVD.
Consult BMW Technical Hotline
Picture color is poor.
Set Brightness/Color/Tint controls to proper settings.
Spots or dotted lines/stripes
appear.
Caused by neon signs, high-voltage power lines, CB
transmitter, and other vehicle's ignition plugs, cell phones,
etc. Change location of the vehicle.
No Remote Control operation or
unstable operation.
Remove any obstacle between System Remote Control
and remote sensor on Monitor.
Replace batteries with new ones. Insert them correctly.
Ensure System Remote Control is being aimed at correct
angle at remote sensor on Monitor. (See page 23)
Clean remote sensor or transmitter.
No sound from headphones.
Turn on POWER to headphone.
Turn up volume on headphones.
Replace batteries in headphones.
Distorted sound from
headphones.
Interference from outside light source, cell phones, etc.
Change location of the vehicle.
Headphone set to wrong channel. Change channel.
Replace batteries with new ones. Insert them correctly.
In Case of Difficulty…
If operation freezes, monitor goes black, or unit should otherwise not function properly, try
turning power ‘OFF’ and then back ‘ON’. Alternatively, try the following methods in the order
listed until DVD Player returns to normal playback mode:
1. Change source from DVD to other source then to DVD mode.
2. Turn vehicle's ignition ‘OFF’ and then back ‘ON’ again.
3. Press RESET button on the face of DVD Player.
If the unit is still at fault, please consult BMW Technical Hotline