Filter
Top Products
7
Installation Instruction P/N 01 29 0 403 646
Wiring Procedure for Vehicle Production 07/05 – On
1. Cut off male pin from violet wire of DVD
Wiring Harness (1) P/N 84 11 0 395 140.
2. Obtain approximately 3 feet of 18 - 20 gauge
wire (2), not included in kit, to be used as
extension wire.
3. Connect end of extension wire (2) to violet
wire with pin removed in Step 22 from DVD
wiring harness (1) using quick connector 61
13 8 364 566 (3)
Note: Black 2-pin connector (4) from DVD
Wiring harness will not be utilized for this
installation.
Note: Ensure that no exposed wires are
present on the quick connect (3) as this
may lead to a short circuit.
4. Remove switching center (2)
5. Route extension wire (1) through center
console and up to opening for switching
center (2).
6. Connect other end of extension wire (2) to
violet/blue wire (3) located in pin location 23
of switching center (1) connector X1869
using quick connector 61 13 8 364 566 (4).
Note: Ensure that no exposed wires are
present on the quick connect (4) as this
may lead to a short circuit.