Boss Audio Systems BV9562I Car Video System User Manual


 
00
3
Contents
10
Additional Information
Simple Troubleshooting Guide 42
On Screen Display
Program Playing
Eject SD Card
Eject USB
35
35
35
35
7
Tuner
Listening to the Radio 36
Band Selector 36
Manual/Automatic Tuning 36
DX/LOC Selector 36
Selecting The stored Station 36
MO/ST Selector 37
AMS 37
Number Buttons 37
On Screen Display 37
Goto FREQ 37
RDS Setup 38
Alternative Frequencies 38
Traffic Alarm 38
Program Type 38
AUX
AUX Touch Screen Menu 39
8
9
IPOD
IPOD Operation 40
Selecting Tracks Fast 40
Playing Track F.F/F.REW 40
Switch 40
Repeat Playing 40
Playing Tracks at Random 40
Pause the Playback 40
File Selector 41
Video or Picture Mode 41
Eject IPOD 41
42
10
Additional Information
Common Symptoms
Cause Solution
There is no power.
The car ignition is
switched off
If the power supply is properly connected to
the car accessory, switch the ignition key to
ON or ACC.
The fuse has blown.
Replace with same amperatge fuse rate.
The disc cannot
be loaded.
There is another disc inside
the player
Remove the disc from the player
The device does not
work correctly
(EJECT, LOAD,
PLAY)
Inserted disc is upside down
Insert the compact disc with the label facing
upward
The surface of disc is extre-
mely dirty, Scrached or
damaged.
Clean the disc or try another disc,if the new
disc works correctly, the first disc is damaged.
Temperature inside the car is
too high.
Cool off until the ambient temperature returns
to normal.
There is no sound.
The volume control is set too
low.
Turn up the volume properly.
The device has not been wired
correctly.
Check the connections according to
the wiring diagram.
The operation keys
do not work
1. The built-in microprocessor
is not operating properly.
2. Front panel is not properly
attached into its place
1. Switch the device off and on again or press
the RESET button.
2. Remove and reinstall the front panel.
The sound of the
disc player skips
The installation angle is more
than30 degrees
The surface of the road is
uneven.
The surface of disc is extremely
dirty,scrached or damaged.
Adjust the installation angle to less than 30
degrees
Wait until the road becomes smoother before
playing the disc.
Clean the disc or try another disc, if the new
disc works correctly, the first disc is damaged.
No radio reception.
The antenna cable is not
connected.
Insert the antenna cable firmly into the antenna
socket of the unit.
In automatic search
mode the radio does
not stop at a trans-
mitting station.
The transmission signals are
too weak.
Tune in to a radio station manually.