Filter
Top Products
11-4 Main Unit Installation (Fixed Mount)
(TOYOTA, NISSAN and other ISO/DIN
equipped vehicles)
This unit is designed for fixed installation in the dashboard.
If the vehicle is equipped with a factory-installed radio, install the main unit with the parts and
screws marked (*).
If the vehicle is not equipped with a factory-installed radio, obtain an installation kit to install the
main unit in the following procedure.
(1) Bend all of side stoppers with a nipper.
(2) Secure the mounting brackets to the chassis as shownin the follow figure. Holes are pre-tapped
for TOYOTA and NISSAN vehicles; modification, such as drilling new holes, of the mounting
brackets may be required for other models.
(3) Wire as shown in chapter 11-6.
(4) Secure the unit in the dashboard, and then reassemble the dashboard and the center panel.
Mounting bracket *
4-Hexagonal screw
(1
pair for the left and right sides)
"(M5X8)~@;
~
*~
*
~
~
Note 2
{l
~
* :The screws with this mark are enclosed
in
this set.
* :The parts and screws with this mark are used to install radio or included in the installation kit.
Note1:
In some cases, the center panel may require some modification (trimming, filling, etc.).
Note 2 : If a hook on the installation bracket interferes with the unit, bend and flatten it with a nipper
or a similar tool.
61