Dolby Laboratories DVD & MP3 Car Video System User Manual


 
INSTALLATION & CONNECTION
30
OUTPUT POWER AMPLIFIER CONNECTION:
Connect an external power amplifier correctly according to the following connection dia-
gram. Incorrect connection will cause incorrect soundstage and also may cause damage
to the speakers.
Note:
In tuner, AUX or DVD stereo mode, the 5.1-CH output is analog.
In 6-CH DVD mode, there is Dolby 5.1-CH output.
FUSE
The inline fuse is rated 10A. If it needs to be replaced, please only use a identical fuse
with identical rating and specs. A wrong fuse value can easily cause a fire or damage the
installed equipment.
TROUBLESHOOTING
If such problem arises during your usage, the troubleshooting guide will settle down all
your problems immediately. If it still doesn’t work, please contact professional technici-
ans to perform.
Symptom Cause Action
Power doesn’t turn on. The unit
doesn’t operate.
Leads and connectors are incorrectly
connected.
Confirm once more that all connections
are correct.
Press [reset] button again.
The fuse is blown.
Rectify the reason for the fuse blowing.
Then replace the fuse. Be sure to
replace the fuse with the same rating.
Noise and other factors are causing
the build-in microprocessor to operate
incorrectly.
Turn the unit off and then on.
Press [reset] button
Operation with the remote control
isn’t possible. The unit does not
operate correctly even when
the appropriate remote control
buttons are pressed.
Battery power is low. Load a new battery.
Some operations are prohibited with
certain DVD discs.
Retry using another disc.
ZE-200DVD Manual E+D_c.indd 30ZE-200DVD Manual E+D_c.indd 30 26.05.2004 14:28:31 Uhr26.05.2004 14:28:31 Uhr