Filter
Top Products
IB-PDV722-WM-E-012007
1. PLAYING A DISC
3 Slide the DVD player main unit’s POWER switch to the ON position, the DVD player starts to
read the disc’s table of contents (this may take a few seconds). the DVD logo (start-up
picture) will appear on the screen.
1 Open the main unit by separating the top and bottom cabinets at the open mark (refer to diagram 1).
2 Place a disc gently on the tray with the label side up, make sure the disc is seated on the
spindle by pressing down in the center (refer to diagram 2), then close the door (refer to
diagram 3).
5 Press the VOLUME + or VOLUME – button to adjust the volume level.
6 Press the SCREEN ON/OFF button on the remote control, then press the left and right
direction buttons to adjust the brightness and the color of the LCD screen if needed. You
can also press the BRIGHTNESS and COLOR buttons on the slave unit to adjust the
slave unit’s LCD screen.
NOTE 1: Load the disc with the label side facing up, when playing a double-sided disc,
load it with the desired playing side face down.
NOTE 2: “NO DISC” will show in the display if the disc is upside down or the disc is badly
scratched or dirty, it will not play. Please clean it or change the disc before use. Also you
can buy a disc polisher to try to repair the scratched disc.
8 To pause the playback, press the OK button on the remote control or the PLAY/PAUSE
button on the main unit. To resume playback, press the OK button on the remote
control or the PLAY/PAUSE button on the player again.
NOTE 1: During play, pressing the STOP button once will show “PRE - STOP ” in the
display, if you press the STOP button the second time, the display will show “ ”, and now
your system is in the full STOP mode.
NOTE 2: Leaving the set in the stop mode for a longer time will drain the battery the same
as during normal play, remember to shut off the power after use.
9 To skip to another track/chapter, press the SKIP/SEARCH or SKIP/SEARCH
button repeatedly during playback.
4 Some discs will start playing automatically, and others will display the disc contents menu
on the screen. If the menu is shown, use the ( , , & ) direction buttons on the
remote to highlight your selection and press the OK button to confirm, otherwise you may
press play.
7 To stop playback, press the STOP button .
16
Diagram 1 Diagram 2 Diagram 3
10 To access the disc menu or title menu during DVD play, press the MENU or TITLE button
on the remote control.
11 Remember to shut off the player by sliding both the main unit and the slave unit’s POWER
switches to the OFF position when the movie finishes playing.
IB-PDV722-WM-E-012007.pmd 2/12/2007, 1:19 AM17