Eclipse - Fujitsu Ten CD5100 Car Stereo System User Manual


 
Cycling through Guidance Points
Use the [SELECT] (Upper/Lower) buttons to cycle back and forth through all of the
Guidance Points.
Upper : Jumps to a later guidance point than that currently being displayed in the guidance
list screen.
Lower : Jumps to an earlier guidance point than that currently being displayed in the
guidance list screen.
NOTE : Depending on where current location is along a given route, some map data may
not be available.
Changing map scale
Press the [SELECT] (Right / Left) button to change map scale.
Right : To switch to a wider range map
Left : To switch to a more detailed map
Route Simulation function
When the system has nished reading the Area Shot data and route simulation is set to ON, a
series of maps is displayed from the starting point to the destination when Area Shot mode is
selected. This allows you to con rm the route to your destination.
While in Area Shot mode, press and hold the [CUSTOM] button for more than one
second.
This activates the Menu Selection mode.
Using the [SELECT] (Upper/Lower) buttons, find the “FUNC” item and press the
[ENTER] button.
This opens the Function Menu.
Using the [SELECT] (Upper/Lower) buttons, find the “Area Shot” item and press the
[ENTER] button.
This accesses the Area Shot settings menu.
Using the [SELECT] (Upper/Lower) buttons, find the “Route Simluation” item and
press the [ENTER] button.
This accesses the Route Simulation setting menu.
Use the [SELECT] (Upper/Lower) buttons to toggle the Route Simulation setting ON/
OFF.
Press the [CUSTOM] or [RTN] button to exit the Menu Selection mode.
Once you have fully exited the Menu Selection screen, the Route Simulation will start and
the “DEMO” icon will flicker.
ATTENTION
The ‘Route Simulation’ is operable only when the Area Shot mode is activated and the Route
Assist is selected.
11
11
11
22
33
44
55
66