Filter
Top Products
Front Panel Features
Power LED
The Power LED lights green when the unit is receiving power.
Config USB Port
Connecting to the USB Port
The mini type B USB port is located on the DP DA2 front panel. It can be used to connect
the distribution amplifier to a host computer for updating firmware or for configuration
using SIS commands. Alternatively, use the RS-232 captive screw connector (see
page9). For complete information about SIS commands, see SIS Commands on
page14.
1. Connect a USB A to mini B cable between the USB Config port on the front panel of
the DPDA2 and the USB port of the PC.
USB Cable
Type A
USB
Mini Type B
USB
USB 1
USB
Ports
Computer
DP DA2 Front Panel
DP DA2
DISPLAYPORT DISTRIBUTION AMPLIFIER
CONFIG
INPUT
OUTPUTS
SIGNAL
HDCP
1 2
Figure 5. Connecting a PC to the DP DA2 Front Panel USB Port
2. If this is the first time a DP DA2 has been connected to the PC, the Found New
Hardware Wizard opens. The first screen offers to search the web for the appropriate
driver needed to communicate with the distribution amplifier via the USB port. This is
not necessary if the USB driver is already on your PC.
DP DA2 • Panel Features 10