Filter
Top Products
PS Engineering
PAV80 Series IFE System
Installation and Operator’s Manual
200-800-0101 Page 2-6 Rev 2 Sept. 2003
2.4.5 Aux Entertainment Audio and AUX Enable
Besides the disc and AM/FM, the PAV80 has the ability to act as a switching control for an additional en-
tertainment input, both audio and video.
The audio input is Pin 7 (R), Pin H (L) with respect to Pin F (ground).
The video input is Pin 17 (with respect to Pin U)
2.5 Unit Installation
To install the PAV80, gently slide the unit into the mounting rack until the hold-down screw is engaged.
While applying gentle pressure to the face of the unit, tighten the 3/32" hex-head in the unit until it is se-
cure. DO NOT OVER TIGHTEN.
Warning: Do not over-tighten the lock down screw while installing the unit in tray.
Internal damage will result.
2.6 PVT801 Display Installation:
The PVT801 is designed to be portable. Install display connectors in a location convenient to the user. The
supplied cable from installed connector to the display is six feet (6’).
Install the 5-pin display connector (550-005-2522) in a location convenient to the user, perhaps close to the
passenger headphone jacks.
A Velcro-strap display case is available from PS Engineering, 1-800-427-2376. In addition, a portable
mounting bracket, PS PN 430-800-1362, is available that can hold the PVA801 with double sided tape.
Figure 2-8 Portable mounting bracket with PVA801 attached
2.7 OPTIONAL PVA802 Video Distribution Amplifier Installation
The PVA802 Distribution amplifier is a remote mounted unit that provides 12 VDC power and composite
video to multiple displays. This should be mounted as close to the display connectors as practical.