Filter
Top Products
PS Engineering
PAV80 Series IFE System
Installation and Operator’s Manual
200-800-0101 Page 2-1 Rev 2 Sept. 2003
Section II - Installation
2.1 GENERAL INFORMATION
2.1.1 SCOPE
These sections provide detailed installation and interconnect instructions for the PAV80
In-Flight Enter-
tainment System with integrated Digital Versatile Disc (DVD) Player and AM/FM radio receiver.
Please read this manual carefully before beginning any installation to prevent damage and post-installation
problems. Installation of this equipment requires special tools and knowledge.
NOTE:
An appropriately rated Certified Aircraft Repair Station must install
this equipment in accordance with applicable regulations. PS Engi-
neering, Incorporated warranty is not valid unless the equipment is
installed by an authorized PS Engineering, Incorporated dealer. Fail-
ure to follow any of the installation instructions, or installation by a
non-certified individual or agency will void the warranty, and may re-
sult in an unairworthy installation.
2.2 Unpacking and Preliminary Inspection
Use care when unpacking the equipment. Inspect the units and parts supplied for visible signs of shipping
damage. Examine the unit for loose or broken buttons, bent knobs, etc. Verify the correct quantity of com-
ponents supplied with the list in Section 1.6 (B). If any claim is to be made, save the shipping material and
contact the freight carrier. Do NOT return units damaged in shipping to PS Engineering. If the unit or an
accessory shows any sign of external shipping damage, contact PS Engineering to arrange for a replace-
ment. Under no circumstances attempt to install a damaged unit in an aircraft. Equipment returned to PS
Engineering for any other reason should be shipped in the original PS Engineering packaging, or other
UPS approved packaging.
2.3 Equipment Installation Procedures
2.3.1 Cooling Requirements
Forced air-cooling of the PAV80 is not required. However, the unit should be kept away from heat produc-
ing sources (i.e. defrost or heater ducts, dropping resistors, heat producing avionics) without adequate cool-
ing air provided.
2.3.2 Mounting Requirements
The PAV80 must be rigidly mounted to the instrument panel or other structure of the aircraft structure and
within view and reach of the persons wishing access. Installation must comply with FAA Advisory Circu-
lar AC 43.13-2A (or later revision). The unit may be mounted in any area where adequate clearance for the
unit and associated wiring bundle exist.
The unit may be installed in any orientation.
Avoid installing the PAV80 close to high current devices or systems with high-voltage, pulse type outputs,
such as DME or transponders.