Filter
Top Products
44
Set up hint
Example) HITACHI DVD
To operate HITACHI DVD player, press and hold the button,
followed by the button.
1. Set up the maker
Press
button to indicate the DVD LED on the remote control.
While the DVD LED is flashing, press and .
2. Set up the maker type
Release the button while keeping button depressed.
Then, press the button.
3. Confirm the setting
After setting the maker and type, press the POWER button on the remote control.
If the DVD does not switch on, repeat step 1 and 2 using other maker types as listed in the chart on .
Changes in the signal status are displayed on the screen as they arise.
NOTE
• Not all models of the listed makers can be operated using this remote control.
Status Display Action
When Frequency Display is set to ON,
the input signal is switched or when
the RECALL button is pressed.
A guide is displayed for the input
terminal and the horizontal and
vertical sync frequency.
When the sync signal is no longer
detected.
• A guide displays No Sync. Signal,
and Power Save (for approx. 5 sec.)
• When the condition continues where
the sync signal cannot be detected,
indicator lamp of power source
changes in orange and the mode
switches to power save mode.
Recheck the personal computer
power switch status and the
connection status.
When the input signal does not match
the monitor specifications or is in an
unstable status.
A guide displays Invalid Scan Freq. Recheck the input signal
specifications. ~
OTHER FEATURES (continued)
DVD Player/STB Selection (continued)
43
Signal Check (RGB mode)
RGB
! No Sync. Signal
! Invalid Scan. Freq.
50 52