Filter
Top Products
unit.
W
Displays the X'over
(HPF)
screen.
(See <High Pass Filter Setup>, page 641
W
Display the X'over
(LPF) screen.
(See <Low Pass Filter Setup>, page 64)
[II Sets up the front speaker type to fine-tune for the
optimal equalizer curves.
Standard: Setup for general diameter speakers
Narrow: Setup for small diameter speakers
Middle: Setup for small diameter woofer
Wide: Setup for large diameter woofer
!ill Select the speakers for Multi-channel sounds.
"3/2":
Center speaker, Front speaker, Rear speaker
"2/2": Front speaker, Rear speaker
"3/0": Center speaker, Front speaker
"2/0": Front speaker
[j]
Set the use or no use of Sub Woofer.
[j]
Displays the Channel Level Setup screen.
IUIDisplays the Car Type Set Up screen.
~
~
.
"X'Over HPF" and "X'Over LPF" can be set only
when "Sub Woofer" is set to
"On".
.To turn
the Center speaker on in the "Multi
channel" settings, turn "Dolby Pro Logic" (see
page 91) on.
!liISelects a speaker to be set.
(see <Channel Level>, page 62)
!illSets the speaker volume.
(see <Channel Level>, page 62)
11m Starts or stops test signal tone output for setup
check.
[l] Displays the Speaker Set Up screen.
~
~
.
Your
setup on the <Sound Effects Menu> is
adjusted automatically to get the best sound
effects according to the car type
and speaker
you
have set on the <Audio Set Up> (see page 60).
We recommend you to complete the <Audio Set
Up> first, then set up the <Sound Effects
Menu>.
You can fine-adjust the automatic set value by
<DTA Setup> (see page
621. <Crossover
Network Setup> (see page
591.or <Parametric
Equalizer> (see page 88)
.Stop the test
signal
tone
if you have finished
setting up the Channel Level. If you leave the test
signal tone
on, you may not be able
to set up
other settings.
English 61