Filter
Top Products
Troubleshooting Guide
does not contain the
one angle.
The viewing angle cannot be changed when the DVDdisc
being played does not contain the recording of more than
one angle.
More than one viewing angle may be recorded only in
limited sections in a disc.
A viewing restriction IRATING) has been set for the
disc.
. Check the viewing restriction level (RATING) setting.
The DVDdisc being played does not contain the
recording of the selected voice or subtitle
.Disc source
Use a DVD disc containing the recording of the selected
voice or subtitle language.
No wire has been connected to the disc changer
input terminal on the unit.
Connect the wire to the disc changer input terminal on the
unit.
The specified CD is quite dirty.
The CD is upside-down.
The disc is loaded in a different slot from that
specified.
The disc is severely scratched.
Clean the CD.
Load the CD with the labeleQ side up.
Eject the disc magazine and check the number for the
specified disc.
Try another disc instead.
Something is touching the disc changer.
The CD is scratched or
Remove whatever is touching it.
Ifskipping happens at the same place when the car is
stopped, something with the CD is wrong. Clean the CD.
. Press the reset button on the unit (see page 41.
The computer chip in the unit is not functioning
normally.
Random play or magazine random play has been
selected.
.Turn off random play or magazine random play.
is not cancelled.
The settings for these functions remain on until the
setting to off or the disc ejected, even if the power is
turned off or the source changed.
The cause is that more than 10 minutes has elapsed
since the vehicle ACC switch was turned OFF.
98 English
The disc can only be removed within 10 minutes of the
ACC switch being turned OFF. if more than 10 minutes
has elapsed, turn the ACC switch ON again and press the
Eject button.