Kenwood DPX-4020 Car Stereo System User Manual


 
— 23 —
switches as follows; (see the equalizer easy mode)
Selecting mode
Press either the FM or AM button.
Each time the button is pressed, the adjustment mode will
change as follows:
Pressing the FM button advances the display, and pressing the
AM button reverses it.
Adjust each mode
Press the 4/¢ button.
Look at the table to adjust the mode being displayed.
Adjustment
mode
(Display)
Bass Center
Frequency
("Bass Frq.")
4 button ¢ button
Operation of control button
Adjust the center frequency of the bass.
"60" / "70" / "80" / "100" (Only when the bass quality factor is
set to 1.00, 1.25 or 1.50) / "150" (Only when the bass
quality factor is set to 2.00) Hz.
Middle Center
Frequency
("Mid Frq.")
Adjust the center frequency of the middle.
"0.5" / "1.0" / "1.5" / "2.0" kHz.
Bass Level
("Bass LV")
Adjust the bass level.
"-12" – "+12"
Bass Quality
Factor
("Bass Q")
Adjust the Bass quality factor.
"1.0" / "1.25" / "1.5" / "2.0"
Middle Level
("Mid LV")
Adjust the middle level.
"-12" – "+12"
Treble Center
Frequency
("Tre Frq.")
Adjust the center frequency of the treble.
"10.0" / "12.5" / "15.0" / "17.5" kHz.
Treble Level
("Tre LV")
Adjust the treble level.
"-12" – "+12"
Middle Quality
Factor
("Mid Q")
Adjust the middle quality factor.
"1.0" / "2.0"
Bass Extend
("Bass EXT")
Switch the Bass Extend mode on/off.
"ON" / "OFF" (When the bass extend mode is set to on, low
frequency response is extended by 20%.)
4
3
Equalizer Preset Memory:
Press the button (#1-3) that you want to use for the Equalizer
curve for at least two seconds.
"EQ Memory#" is displayed, indicating that the Equalizer curve
is stored in the selected button.
Recalling a Equalizer you stored:
Press the preset button (#1-3) for the desired Equalizer curve.
Press the EQ button for at least one second to end the
equalizer pro mode.
If you make no button operation for 10 seconds, the equalizer
pro mode is automatically canceled.
When each setting item is adjusted "User" is displayed. In this
condition Equalizer Preset Memory is not used.
NOTE
6
5
03.DPX-4020_M_US_PH4 02.6.3 3:54 PM Page 23