Kenwood DPX-4020 Car Stereo System User Manual


 
— 25 —
Function items in Standby mode:
You can adjust the Dimmer level of the unit when your car's
light switch has been turned on.
Display and setting:
"DIM STEP 1" – "DIM STEP 13"
This function is available when the dimmer wire is connected and
the light switch of your car is turned on.
NOTE
Dimmer Level Adjustment
This function produces a beep sound that accompanies button
operation. It can be switched on or off.
Display and setting:
"BEEP On" : Beep setting is on.
"BEEP Off" : Beep setting is off.
The beep sound is not output from the preout jacks.
NOTE
Touch Sensor Tone
Switch the preout between the rear and non-fading. The
factory default is rear preout.
Display and setting:
"Preout Rear" : Rear preout
"Preout N-F" : Non-fading preout
Switching preout
If this function is set to on, the opening display appears when
the power is turned on.
Display and setting:
”Opening On“ : Opening display function is on.
”Opening Off“ : Opening display function is off.
Opening Display
Select 1 of 2 equalizer modes, the preset “EASY” mode, or the
“PRO” mode where the individual items can be adjusted.
Display and setting:
Select the display "EQ mode" during the selecting function in
the function set system.
Press either the 4 or ¢ button for at least two seconds to
turn the function.
”EQ mode EASY“ : Equalizer Easy mode.
”EQ mode PRO“ : Equalizer Pro mode.
2
1
Equalizer Mode
03.DPX-4020_M_US_PH4 02.6.3 3:54 PM Page 25