Filter
Top Products
— 40 —
English
Installation type 1
■
DPX-5010
Use Accessory1 to attach the
unit which was assembled in
Assembly.
1
Install the center panel
with the unit in your car.
The illustration shows an
example of installation
using a vehicle bracket.
The shape of the bracket
varies with the vehicle to
be installed. Some bracket
requires three screws
(Accessory1) on each side.
NOTE
2
Accessory1
(M5 × 6 mm)
Installation (for HONDA ACURA Car)
Assembly
■
Bottom
panel
(The application
position of
Accessory5 is at the
bottom panel)
Fit the projections on both sides of the
Accessories 6 and 7 into the slits on
the Accessory4.
Accessory4
Accessory0
(M5 × 6 mm)
Accessory7 (R)
Accessory6 (L)
Accessory0
(M5 × 6 mm)
If accessories 6 and 7 hit the inside of the console, preventing
the unit from being attached tightly, snap their end parts off as
shown below.shipped with the unit, as shown above.
NOTE
Be careful not to get injured with the new edge.
2CAUTION
Accessory67
You can choose from three installation types to fit your car.
Perform "Assembly" before installation.