Filter
Top Products
English
|
33
Preset Memory
Putting the channel in the memory.
1 Select the channel to put in the memory
Push the [AUD] knob towards right or left.
2 Enter Preset Memory mode
Press the [SEARCH] button.
3 Select the number to put in the memory
Turn the [AUD] knob or push it towards up or
down.
4 Determine the number to put in the memory
Press the [AUD] knob for at least 1 second.
Cancelling the Preset Memory mode
Press the [SEARCH] button.
⁄
• Only the channel number is stored. Category information
is not stored.
Preset Tuning
Recalling the channels in the memory.
1 Enter Preset Tuning Select mode
Press the [SEARCH] button.
2 Select a desired station in the memory
Turn the [AUD] knob or push it towards up or
down.
3 Recall the station
Press the [AUD] knob.
Cancelling Preset Tuning
Press the [SEARCH] button.
Function of remote control
Direct Access Tuning
Entering the channel and tuning.
1 Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
2 Enter the channel
Press the number buttons.
3 Do Channel Search
Press the [4] or [¢] button.
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
⁄
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• If you cannot receive any signal in the input Channel due
to bad conditions on radio wave or other such problems,
“ACQUIRING SIGNAL”/ “NO SIGNAL” appears.
Channel Scan
Every receivable Channel is checked for 10 seconds.
1 Start Channel Scan
Select “CH-SCAN”.
For how to select Function Control items, refer to
<Function Control> (page 6).
2 Release it when the channel you want to listen
to is received
Press the [AUD] knob.
⁄
• You cannot Channel search until the category
information is acquired.