Filter
Top Products
11
!7 Works as an S-meter in the receive mode. Works as
the meter you selected while transmitting.
!8 “ ” appears when the internal TNC is assigned to the
main transceiver.
!9 The Hz digits of the main transceiver operating
frequency appears.
@0 Appears when the frequency point of Program Scan
Partially Slowed is selected on the main transceiver.
@1 When the sub-receiver is switched ON, it shows the
operating frequency for the sub-receiver. However, if
you are controlling the main transceiver functions,
such as RIT, XIT or SPLIT, it displays the frequency
information for these functions.
@2 Serves as an S-meter for the sub-receiver. It also
displays the relative output power when the sub-band
is selected for transmission.
@3 Appears when the MHz Up/ Down mode is selected.
@4 Appears when the Fine tuning function is selected.
@5 “PKT” appears when the internal TNC is operating in
Packet mode.
@6 “tM” or “Ms” appears while a simplex memory
channel is selected. “tMs” appears while a split
frequency memory channel is selected.
@7 “tB” or “Bs” appears while VFO B is selected. “B”
appears while Menu B is being accessed.
@8 “tA” or “As” appears while VFO A is selected. “A”
appears while Menu A is being accessed.
@9 “DSP” appears when one of the DSP functions is
activated.
#0 “AGC” appears when the AGC function is ON. “R”
(Reverse function), “[R]” (Automatic Simplex Check),
or the Repeater shift direction (“–”, “+”, or “=”)
appears.
Note: “=” appears only for E-types.
#1 “ATT” appears when the attenuator function is ON.
“PRE” appears when the preamplifier function is ON.
“P/A” appears when both functions are ON.
#2 “RtEQ” appears when the RX Equalizer function of
the main transceiver is ON. “EQsT” appears when
the TX equalizer function is ON.
#3 “EXT” appears while the HF RX ANT connector is
enabled to receive HF band signals.
#4 “NB” appears when the Noise Blanker function is ON.
#5 “A” appears when Auto mode selection is activated.
#6 The current operating mode for the main transceiver
appears.
#7 “PROC” appears when the Speech Processor
function is ON.
#8 “PTT” appears when the main transceiver is selected
for the transmission band. “Ctrl” appears when the
main transceiver is selected for the Control band.
#9 “VOX” appears when the VOX function is ON.