Filter
Top Products
40
Note:
◆
You can press the Tuning control to change the Tuning control
and MULTI/ CH control to adjust the operating frequency. “TUN”
or “MLTI” appears to indicate which control mode is selected.
◆
If you start Visual Scan in Memory Recall mode, the memory
channel frequencies will be scanned.
◆
Visual Scan stops while transmitting.
◆
During the Visual Scan, the scanning frequency cannot be
monitored through the speaker.
◆
Depending on conditions, Visual Scan and the conventional
S-meter may indicate different signal strength levels.
USING VISUAL SCAN
1 Select your desired frequency using the Tuning
control.
2 Turn the Tuning control or press Mic [UP]/ [DWN]
to select the operating frequency.
• This frequency will be used as the center frequency
for the Visual Scan.
3 Press [F1] (1 s) until you select group B.
4 Press [F1] until you select B–3.
5 Press [VISUAL] to start the Visual Scan.
• To pause the Scan, press [PAUSE]. “P” appears on
the display. Press [PAUSE] again to resume
scanning.
6 To change the center frequency, turn the Tuning
control or press Mic [UP]/ [DWN].
• The displayed frequency changes and the cursor
moves.
• Press [SET] to use the changed operating frequency
as the center frequency.
• Press [RESET] to restore the original center
frequency.
7 To quit Visual Scan, press [EXIT].